Nano LED’s by Motown Models are the perfect upgrade for your model’s lighting system. Compared to traditional bulbs, Nano LED’s are smaller, brighter, last longer, and draw less power. With LED dimensions of 1 x 0.5mm, there are few places Nano LED’s cannot fit.

The Lens option includes a HO scale 6” (2mm, 0.070”) lens pre-attached to the LED, allowing easy installation into nearly any HO diesel headlight housing.

The Protected Lens option is the same as above, but has a small piece of heat shrink tubing installed on the back of the Lens assembly. This is a good option for when short circuits could happen during mounting, like in brass models or metal headlight/ditch light housings. It also helps reduce light bleed around the LED.

Each kit includes the LED’s, 2.2kΩ 1/8W resistors, heat shrink tubing, and instructions.

Technical specs:

• LED dimensions: 0.5 x 1mm

• Wire length: 20cm (7.75in)

• Operating voltage (with resistor): 8-14V

• Current consumption: 20mA